TODO en 1 / ALL in one: UNI-500
Search, LED flashing, and remote control transmits power signal every 2.0 seconds
automatically.
F.
See if the device react or not, once the device reacts, press any key(except SET key) to stop
the auto search.
G.
Test if the other keys work good enough. If most keys work not good enough, please go to step
B-D using Auto Search again to find the best code.
Remark:
D.
whenever you want to leave Auto Search mode, press any key (except SET key) to quit, and
the LED will be off. The search is over.
E.
When remote control searches through all different type of codes (about 5 minutes), LED will
have been on for 2 seconds, then the remote control will quit from search process
automatically.
F.
In case of you do not stop the auto search on time when you find the device react, you may use
Manual Search to search back to find the reactive code.
4. Device code display:
The device code is a 3-digit number and any one of the digits can be indicated:
D.
Press and hold the [SET] key, in the mean time press the digit that you want to display, such as
1,2or3.
E.
Release the both pressed keys.
F.
Count the times that the LED blinks, and the blinking time is the digit. If there is no blink, the
digit is zero.
For example:
SET+1(first digit):
SET+2(second digit):
SET+3(third digit):
The indicated code is:
Others
A.) After you have finished set-up, first please press the device key (TV or VCR...) on remote
control that you want to use, then operate your remote control normally.
B.) If you find your remote control disorder, In such a case, just take the batteries for 20minutes,
place in batteries again and it will be restored to normal state.
C.) Technical parameters:
Control distance: more than 8m(varies according to your appliance type).
Battery type: 2 units AAA batteries
Dimensions:195Lx55W65*18H mm Weight : approx.100g
LED blinks 1 time
LED blinks 3 times
LED blinks 8 times
138
Página 9