Installation - Textron Greenlee CTF-200 Manual De Instrucciones

Installation

1. Place single mount leg up on the side of the tray.
2. Set the proper distance of the opposing leg to
match the tray width by disengaging the pin (1) from
the leg weldment (2) and the cross bar.
3. Draw out the strap from the ratcheting mechanism
and hook to the opposing leg hook.
Greenlee / A Textron Company
4. Ratchet the strap to secure the mount to the tray.
Be sure it is tight enough to hold the mount. Do
not overtighten as this may damage the ratcheting
mechanism or the tray.
5. CTF-200EXT only: Adjust the height of the cross
bar (2) using the pull pins (1) from the lower mount-
ing legs.
2
1
6. Mount the feeder according to which direction the
cable is to be fed by disengaging the pull pin and
setting the feeder on the cross bar. Slide the feeder
along the cross bar to the desired position to feed
cable. Be sure that the pull pin properly engages
into a hole on the cross bar.
7. CTF-200EXT only: To install the 2–4" extended
idler roller, remove the 2" idler roller by squeezing
the detent pins together on each side; the idler will
drop off. Install the 2–4" extended idler roller in the
reverse manner. Refer to step 1 in the "Operation"
section for detent pin squeeze.
8
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070
CTF-200 • CTF-200EXT
2
1
1