EDM 03223 Instrucciones Importantes De Seguridad página 9

03223
REF.
INSTRUÇÕES IMPORTANTES DE SEGURANÇA / IMPORTANT SAFETY INSTRUCTIONS
CONNECTION
WARNING. DANGER OF DEATH THROUGH ELECTRIC SHOCK!
Must be installed by professional electrician.
- Disconnect power source.
- Cover or shied any adjacent live components.
- Ensure device cannot be switched on.
- Check power supply is disconnected
- Unload the faceplate of sensor and adjust the time and LUX knob.(refer to figure 1)
- Loosen the screw in the back and unload the bottom (refer to figure 1).
- Install back the transparent vinyl cover into the original location.
- Fold the metal spring of the sensor upwards, until they are in "I" position with sensor, and then put the
sensor into the hole or installation box which is on the ceiling and has the similar size with the sensor. Relea-
sing the spring, the sensor will be set in this installation position.
- After finishing installing, turn on the power and then test it.
STEP 1
CONNECTION-WIRE DIAGRAM (See the right figure)
TEST
- Turn the TIME knob anti-clockwise on the minimum (10s).Turn the LUX knob clockwise on the maximum
(sun).
- Switch on the power; the sensor and its connected lamp will have no signal at the beginning. After
Warm-up 30sec, the sensor can start work .If the sensor receives the induction signal, the lamp will turn on.
While there is no another induction signal any more, the load should stop working within 10sec±3sec and the
lamp would turn off.
- Turn LUX knob anti-clockwise on the minimum (3). If the ambient light is more than 3LUX, the sensor would
not work and the lamp stop working too. If the ambient light is less than 3LUX (darkness), the sensor would
work. Under no induction signal condition, the sensor should stop working within 10sec±3sec.
INSTRUCCIONES IMPORTANTES DE SEGURIDAD
STEP 2
-9-
STEP 3