Stiga T8612 Manual Del Usuario página 5

19. Repeat steps 1 through 12 on second table half.
20. Gently tap caster sockets #12 into U-support #7 on second table
half until flange on sockets touches the edge of the tube. DO NOT
HIT CASTER SOCKETS TOO HARD WITH A HAMMER. Cast-
ers could break if hit too hard.
21. Insert casters #11 into caster sockets #12 on second table half.
22. Attach linkages #4 to the OUTSIDE of U-support #7 on second
table half. Use screws #14, plastic washers #24 and hex nuts #15.
NOTE: Tighten locknuts #15 finger tight only. They will be
removed when the two table top halves are connected.
Attach Strap #6 to the
INSIDE of U-Leg #2.
AT LEAST TWO ADULTS ARE NEEDED TO
COMPLETE THE REMAINDER OF THE
Figure 9
5
CAUTION:
ASSEMBLY!