Kokido RC 16 Manual De Usuario página 10

2. Detach the filter cover and remove the debris from the compartment. It is recommended to clean the filter cover net with
splashing water. If brushing is deemed necessary, use only a soft brush to clean it carefully and gently to avoid damages.
3. After cleaning, make sure that the filter cover is in place and reverse the steps above to re-align the top cover to the base.
Press on both sides of the top cover until the side clips are secured to the base. A "click" sound will confirm the top cover
is secured to the base.
TIPS: Before redeploying the robot to the pool, hold onto the wings on the body top cover to sway the robot slightly, to ensure
the top cover is secured to the base.
CAUTION!
- Replace a damaged filter cover immediately with a new one before the next operation.
- Replace a damaged float immediately with a new one before the next operation.
Float Replacement
Use a screwdriver (not provided) to unscrew the 4 screws at on the top cover of the swivel head. Untie the knot on the string
to remove the damaged float. Ensure the round switch is in place before sliding the string of the new float through the top cover
and tying a knot to keep it in place, and then re-install the top cover with screws.
- Replace a damaged flap immediately with a new one before the next operation.
Flap replacement
9