Craftsman CMXPTSG1014NB Manual De Instrucciones página 11

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

ENGLISH
MAINTENANCE
WARNING: ALWAYS DISCONNECT TOOL FROM THE AIR SUPPLY BEFORE PERFORMING ANY
MAINTENANCE ON THE TOOL.
WARNING: Always make sure the tool is properly lubricated during operation. Proper
lubrication is shown in this instruction manual.
An in-line oiler (not included) is recommended to help increase tool life and keep the tool
properly lubricated. The in-line oiler should be regularly checked and filled with air tool oil as
needed. Proper adjustment of the in-line oiler can be performed by placing a sheet of paper
next to the tool's exhaust ports while holding the throttle completely open for 30 seconds.
When a light stain of oil collects on the paper, the oiler is properly adjusted. Excessive
amounts of oil should be avoided.
Recommended lubricants: air-tool oil or any other high grade turbine oil containing moisture
absorbent, rust inhibitors, metal wetting agents and an EP (Extreme Pressure) additive.
Consult your local retailer for further assistance in selecting air tool oil best suited for proper
lubrication.
Cleaning
WARNING: Blow dirt and dust out of all air vents with clean, dry air at least once a week.
To minimize the risk of eye injury, always wear ANSI Z87.1 approved eye protection when
performing this.
WARNING: Never use solvents or other harsh chemicals for cleaning the non-metallic
parts of the tool. These chemicals may weaken the plastic materials used in these parts.
Use a cloth dampened only with water and mild soap. Never let any liquid get inside the
tool; never immerse any part of the tool into a liquid.
Repairs
WARNING: To assure product SAFETY and RELIABILITY, repairs, maintenance should be
performed by a CRAFTSMAN factory service center or a CRAFTSMAN authorized service
center. Always use identical replacement parts.
Accessories
WARNING: Since accessories, other than those offered by CRAFTSMAN, have not been
tested with this product, use of such accessories with this tool could be hazardous. To
reduce the risk of injury, only CRAFTSMAN recommended accessories should be used with
this product.
Recommended accessories for use with your tool are available at extra cost from your local
dealer or authorized service center. If you need assistance in locating any accessory, please visit
CRAFTSMAN.COM or call 1-888-331-4569.
Storage
Before you store the tool, make sure you do the following:
1. Review the Maintenance section on the preceding pages and perform scheduled
maintenance as necessary.
2. Tool must be well cleaned and lightly lubricated before storing.
3. Store the tool in a dry, safe place out of the reach of children.
10

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido