König Electronic CMP-BLUEHS11 Manual De Uso página 3

Usage of the CMP-BLUEHS11
1. Switching the headset on/off
Function
Switch on the headset Press
Switch off the headset Press
Remarks:
* The headset will switch off automatically if no device is connected after 5 minutes in order to save power.
2. Pairing the headset with Bluetooth devices
2.1. How to enter the pairing mode
Function
Enter into pairing
mode
Note:
* The pairing mode will last 2 minutes. If the headset still cannot pair with any Bluetooth devices, it will
automatically switch into standby mode.
2.2. Pairing the headset with a Bluetooth mobile phone
Please make sure your mobile phone has a Bluetooth function.
Specific pairing procedures may vary with different mobile phones. Please refer to your mobile phones'
manual for further information. The steps are as follows:
a. Please keep the headset and mobile phone within 1 metre of each other when pairing
b. Make the headset enter the pairing mode (please refer to 2.1)
c. Switch on the Bluetooth function of the mobile phone and search for Bluetooth devices. When the search
is completed, select the headset in the Bluetooth device list.
d. When prompted, enter PIN No: "0000" as the password and press "Yes" or "Confirm".
e. After pairing the devices successfully, select the headset in the Bluetooth device list and press "Connect".
f. If the connection is successful, the blue LED of the headset blinks twice every 4 seconds.
Note:
* If the pairing is not successful, please switch off headset first then try to pair them again according to the
steps mentioned above.
* After pairing, the devices will remember each other.
* The headset can remember 8 paired devices, when the number of paired devices exceeds 8, the first
one will be replaced. If you want to pair the headset with other devices, please pair it with the new device
according to the steps above.
3. Pairing the headset with a Bluetooth transmitter
You can enjoy music wirelessly by connecting the headset with a stereo Bluetooth transmitter. See the
manual of your transmitter for more details.
4. Making a call with the headset
Function
Voice dial
Redial last number
Volume down
Operation
O the for 3-5 seconds,
and release until the blue LED
blinks
O the for 3-5 seconds,
and release until the red LED
blinks
Operation
First, make sure the headset
is off. Press O for 5-9 seconds
and release until the red and
blue LEDs blink alternately
Status of the headset
Standby mode
Standby mode
Conversation mode
Conversation mode
LED indicator
The blue LED blinks quickly in
every 4 seconds4s a time
The red LED blinks quickly in
every 4 seconds4s a time
LED indicator
The red and blue LEDs blink
alternately
Operation
Press ˘ for 2 seconds and release until a tone is heard
Short press twice
O
Move switch two to + and then release (or hold) it
Move switch one to – and then release (or hold) it
3
Indication tone
One long tone
One long tone
Indication tone
Two tones