Natural Gas Conversion - Agio 1031541 Instrucciones De Ensamblado

NATURAL GAS CONVERSION

Natural gas conversion must be performed only by your natural gas provider or
service company.
Step 1- At the control panel, disconnect the rubber gas hose from the gas valve.
Step 2- Below the burner, disconnect the aluminum gas tube from the orifice elbow.
Step 3- Remove the 2 M4 nuts from the orifice holder and remove the orifice bracket
assembly.
Step 4- Disconnect the orifice from the elbow and replace it with the Natural Gas orifice
from the kit.
Re-fit the orifice bracket assembly onto the holder using the 2 M4 screws and nuts.
Re-connect the aluminum gas tube into the end of the elbow. Connect your Natural Gas
supply line onto the gas valve at the control panel. BEFORE ATTEMPTING TO USE
THE FIREPIT, check ALL of the connections for leaks using a solution of soapy water. If
a leak is discovered and any bubbles are seen, close the main gas valve and re-tighten
ALL the connections. NEVER USE A FLAME TO CHECK FOR GAS LEAKS!
8
Jul-01-2016