° NEVER store a spare LP cylinder
under or near the
appliance
or in an enclosed area.
° Never fill a cylinder
beyond 80% full.
• If the information
in the two
points
above
is not
followed
exactly,
a fire causing
death
or serious
injury may
occur.
• An overfilled
or improperly
stored
cylinder
is a
hazard
due to possible gas release
from the safety
relief valve.
This could
cause
an intense fire with
risk of property
damage,
serious injury or death.
• If you see, smell or hear gas
escaping,
immediately
get away
from the LP cylinder
and
appliance
and call your fire department.
LP Tank Removal, Transport And Storage
• TurnOFF all control knobs and LPtank valve. Turn coupling nut
counterclockwise by hand only - do not usetools to
disconnect. Lift LPtank wire upward off of LPtank collar, then lift
LPtank up and off of support bracket. Install safety cap onto LP
tank valve. Always use cap and strap supplied with valve.
Failure to use safety cap as directed may result in serious
personal injury and/or property damage.
LPTank Valve.,
_'_
_Safety
Cap
_'_
_Retainer Strap
• A disconnected
LP tank in storage or being transported
must
have a safety cap installed (as shown). Do not store an LPtank
in enclosed spaces such as a carport, garage, porch, covered
patio or other building. Never leave an LPtank inside a vehicle
which may become overheated
by the sun.
• Do not store an LPtank in an area where children play.
LP Cylinder
• The LPcylinder used with your grill must meet the following
requirements:
• Use LPcylinders only with these required measurements: 12"
(30.5cm) (diameter) x 18" (45.7 cm) (tall) with 20 lb. (9 kg.)
Capacity
maximum.
• LPcylinders must be constructed and marked in accordance
with specifications
for LPcylinders of the U.S. Department of
Transportation
(DOT) or for Canada, CAN/CSA-B339,
cylinders, spheres and tubes for transportation
of dangerous
goods. Transport Canada (TC). See LPcylinder collar for
marking.
• LPcylinder valve must have:
• Type 1 outlet compatible
with
regulator or grill.
• Safety relief valve.
• UL listed Overfill Protection
Device (OPD). This OPD safety
OPD Hand Wheel
feature is identified by a unique triangular hand wheel. Use
only LP cylinders equipped with this type of valve.
• LPcylinder must be arranged for vapor withdrawal
and
include collar to protect LPcylinder valve. Always keep LP
cylinders in upright position during use, transit or storage.
LPcylinder in upright position for vapor withdrawal
LP (Liquefied
Petroleum
Gas)
• LPgas is nontoxic, odorless and colorless when produced.
For
Your Safety, LPgas has been given an odor (similar to rotten
cabbage)
so that it can be smelled.
• LPgas is highly flammable and may ignite unexpectedly
when
mixed with air.
LP Cylinder
Filling
• Use only licensed and experienced
dealers.
• LPdealer must purge new cylinder before filling.
• Dealer should NEVER fill LPcylinder more than 80% of LP
cylinder volume. Volume of propane in cylinder wilt vary by
temperature.
• A frosty regulator indicates gas overfill. Immediately close LP
cylinder valve and call local LPgas dealer for assistance.
• Do not release liquid propane (LP) gas into the atmosphere. This
is a hazardous practice.
• To remove gas from LP cylinder, contact an LPdealer or call a
local fire department for assistance. Check the telephone
directory under "Gas Companies" for nearest certified LP
dealers.
6 ° 33585-30800367