Husqvarna TS 242XD Manual De Operario página 22

Ocultar thumbs Ver también para TS 242XD:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

SERVICE AND ADJUSTMENTS
TO CHECK BRAKE
If tractor requires more than fi ve (5) feet (1.5 m) to stop at
highest speed in high est gear on a level, dry concrete or
paved surface, then brake must be serviced.
You may also check brake by:
1. Park tractor on a level, dry concrete or paved surface,
depress brake pedal all the way down and engage
parking brake.
2. Disengage transmission by placing freewheel control
in "transmission disengaged" position. Pull freewheel
control out and into the slot and release so it is held in
the disengaged position.
The rear wheels must lock and skid when you try to manually
push the tractor forward. If the rear wheels rotate, then the
brake needs to be serviced. Contact a qualifi ed service center.
TO REPLACE MOWER BLADE DRIVE BELT
MOWER DRIVE BELT REMOVAL (See Fig. 32)
Park tractor on a level surface. En gage parking brake.
Lower attachment lift lever to its lowest position.
Remove mandrel covers.
Remove any dirt or grass clippings which may have
accumulated around mandrels and entire upper deck
surface.
Remove nut and pulley guard.
Remove spring from eyebolt.
Remove belt from all pulleys.
Remove the belt from around the electric clutch on the
engine shaft.
IDLER
MANDREL
PULLEY
COVER
MANDREL
PULLEY
EYEBOLT
SPRING
IDLER
ARM
ELECTRIC
BELT
CLUTCH
MANDREL
PULLEY
MANDREL
PULLEY
GUARD
Fig. 32
MOWER DRIVE BELT INSTALLATION (See Fig. 33 & 34)
NOTE: For ease in installing the deck belt, refer to the
routing decal on the cutting deck.
Place the belt around all pulleys.
Double check belt routing to make sure it matches the
routing decal, and that the belt does not have any twist.
Correct if needed.
BELT ROUTING
BLADE BELT
MANDREL
PULLEY
Connect spring to eyebolt.
Install pulley guard and nut previously removed.
Adjust belt tension until spring is extended to a length
of 6.5" (16,5 cm):
- Loosen inner adjustment nut.
- Turn outer adjustment nut clockwise ( ) to increase
tension, counterclockwise ( ) to decrease tension.
- Tighten inner adjustment nut securely.
INNER ADJUSTMENT NUT
OUTER
COVER
ADJUSTMENT
NUT
Replace mandrel covers on both mandrel housings
and secure with fasteners.
FRONT WHEEL TOE-IN/CAMBER
Your new tractor front wheel toe-in and camber is set at the
factory and is normal. The front wheel toe-in and camber
NUT
are not adjustable. If damage has occurred to affect the
factory set front wheel toe-in or camber, contact a qualifi ed
service center.
22
ENGINE
PULLEY
IDLER
PULLEY
MANDREL
PULLEY
Fig. 33
EYEBOLT
SPRING
Fig. 34

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido