Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
3. Within 120 seconds after the power light on HomePlug D starts to flash, press and hold the security
button on HomePlug B for 2 seconds and then release.
4. HomePlug B and HomePlug D are now connected to each other.. Therefore, together with
HomePlug E, they will form the network BDE.
Chapter 3: Troubleshooting & disclaimer
If your HomePlug AV Ethernet Bridge has difficulty communicating with each other, check the
following:
•
Try power cycling the unit by unplugging it from the wall socket for 10 seconds and plug it in again.
•
Use a paperclip to press and hold the Reset button on each HomePlug for 2 seconds and try to
re-connect. The HomePlug's light will flash, and the HomePlug will be reset and attempt to link
using the default factory settings.
•
Try plugging the HomePlug into an adjacent power outlet.
•
The HomePlug works better when plugged directly into the wall power outlet. Connecting the
HomePlug to a power strip or surge protector may degrade the network performance or completely
stop network signals.
•
This HomePlug should not be used in areas with excessive heat.
•
Certain florescent or incandescent lights are noise sources for the electrical wiring and can
degrade the performance.
•
If your building has more than one circuit breaker box, your HomePlug may not be able to connect
between the different circuit breaker boxes. In this case, connect one HomePlug to a power outlet
located on each of the circuit boxes. Connect an Ethernet cable between each of the HomePlug
units to link the different HomePlug together. This will allow the HomePlug units from different
circuit breaker boxes to be connected.
Disclaimer: This product was designed to be plugged directly into a wall socket as shown in the
diagram below. Any other use may hamper the function of the product.
Safety precautions:
Maintenance:
Clean the product only with a dry cloth.
Do not use cleaning solvents or abrasives.
To reduce risk of electric shock, this product should ONLY be
opened by an authorised technician when service is
required. Disconnect the product from mains and other
equipment if a problem occurs. Do not expose the product to
water or moisture.
6
Publicidad
Tabla de contenido
