Replacing The Power Cable; Cleaning And Maintenance; Carbon Brushes; Disposal And Recycling - EINHELL Expert TE-CS 190/1 Manual De Instrucciones

Anleitung_TE_CS_190_1_SPK8a__ 18.10.12 08:12 Seite 35
6.4 Changing the saw blade (Fig. 13-16)
Important. Always pull out the power plug
before doing any work on the circular saw!
Only use saw blades of the same type as the saw
blade supplied with this circular saw. Ask your dealer
for advice. Do not use grinding wheels.
Use the saw blade key (13) supplied to change the
saw blade. The saw blade key (13) is stored in the
housing. If required, pull the saw blade key (13) out of
the housing (see Figure 13).
Important. The hand-held circular saw must not be
operated with the saw blade key (13) inserted in it.
Press the spindle lock (11).
Undo the screw to secure the saw blade (17)
using the saw blade key (13).
Push back and secure the moving swing guard
hood (19) using the lever for the swing guard
hood (20).
Remove the flange (18) and the saw blade (12) in
a downwards direction.
Clean the flange and insert the new saw blade.
Pay attention to the running direction (see arrow
on the guard hood and saw blade).
Tighten the screw to secure the saw blade (17),
check it runs true.
Before you press the On/Off switch, make sure
that the saw blade is correctly fitted and that
moving parts run smoothly and the clamping
screws are tightened securely.
6.5 Using the LED light (Figure 17)
The LED light (23) can be used in poor lighting
conditions to additionally illuminate the cutting
position.
To switch on the LED illumination press the switch
(22).
To switch off the LED light (23) press the switch for
LED illumination (22) again.
Always switch off the LED light when not in use.
The LED light is powered by the mains voltage.
Batteries are therefore not required.

7. Replacing the power cable

If the power cable for this equipment is damaged, it
must be replaced by the manufacturer or its after-
sales service or similarly trained personnel to avoid
danger.

8. Cleaning and maintenance

Always pull out the mains power plug before starting
any cleaning work.
8.1 Cleaning
Keep all safety devices, air vents and the motor
n
housing free of dirt and dust as far as possible.
Wipe the equipment with a clean cloth or blow it
with compressed air at low pressure.
We recommend that you clean the device
n
immediately each time you have finished using it.
Clean the equipment regularly with a moist cloth
n
and some soft soap. Do not use cleaning agents
or solvents; these could attack the plastic parts of
the equipment. Ensure that no water can seep
into the device.

8.2 Carbon brushes

In case of excessive sparking, have the carbon
brushes checked only by a qualified electrician.
Important! The carbon brushes should not be rep
laced by anyone but a qualified electrician.
8.3 Maintenance
There are no parts inside the equipment which
require additional maintenance.

9. Disposal and recycling

The unit is supplied in packaging to prevent its being
damaged in transit. This packaging is raw material
and can therefore be reused or can be returned to
the raw material system.
The unit and its accessories are made of various
types of material, such as metal and plastic.
Defective components must be disposed of as
special waste. Ask your dealer or your local council.

10. Storage

Store the equipment and accessories out of children's
reach in a dark and dry place at above freezing
temperature. The ideal storage temperature is
between 5 and 30 °C. Store the electric tool in its
original packaging.
GB
35