BLUE SKY WBFB29-MD Manual Del Usuario página 7

ASSEMBLY
TOOLS REQUIRED: PHILLIPS SCREWDRIVER, PLIERS
NOTE: USE TWO PEOPLE TO LIFT AND TURN THE FIRE BARREL.
NOTE: TO ENSURE AN EASIER ASSEMBLY, WE STRONGLY ADVISE
ONLY FINGER TIGHTENING BOLTS DURING INITIAL ASSEMBLY. ONCE
ALL BOLTS ARE INSERTED, FULLY TIGHTEN ALL BOLTS. DO NOT
OVERTIGHTEN.
NOTE: BOLTS SHOULD BE INSERTED THROUGH WASHERS (WHERE
APPLICABLE) AND THROUGH THE OUTSIDE OF THE FIRE PIT, THEN
SECURED WITH NUTS ON THE INSIDE.
STEP 1
Carefully turn the fire bowl [H] on
its side on a soft surface to protect
the finish.
Attach the three legs [I] to the bottom
of the fire bowl using four M6 x 10
bolts [K], Ø6 x 20 mm washers [M]
and M6 nuts [L] per leg.
Make sure to tighten all bolts, but do
not overtighten.
Turn the fire bowl upright.
STEP 2
Attach the four grate supports [E] and
four upper ring supports [F] to the fire
bowl [H] using four M6 x 10 bolts [K]
and M6 nuts [L].
NOTE: It is important to keep
all supports straight after they
are assembled.
K M L
I
E
L
H
H
F
K
7