Practical Tips - Taurus G60BKAL Manual De Instrucciones

FILTER CLEANING INDICATOR
 The first time you turn on the appliance, or after
14 hours of working time, the filter cleaning
indicator will turn on.
DECREASE KEY
 In normal use press to decrease the engine
power level.
 In timer mode it can be used to reduce the
programmed time, every time you press it you
will lower 1 minute, press and hold to decrease
the time quickly.
 If you are adjusting the clock time, each time
you press it will lower 1 minute, press and hold
to decrease the time quickly.
INCREASE KEY
 In normal use press to increase the engine
power level.
 In timer mode it can be used to increase the
programmed time, each time you press it will
increase 1 minute, press and hold to increase
the time quickly.
 If you are adjusting the clock time, each time
you press will increase 1 minute, press and
hold to increase the time quickly.
TIMER MODE
 Press this button to activate the timer, they will
add 5 minutes (it can be programmed between
5 and 60 minutes). If no button is pressed
within 10 seconds, the settings will be saved.
 To set the clock press and hold this button for 3
seconds, the three keys necessary to set the
clock will be activated. Once the clock is set, if
no button is pressed within 10 seconds, the
setting will be saved.
LIGHT BUTTON
 Press to turn the light on or off.
 If you hold down the time you will see the
engine running time, stop pressing and this
time will disappear in 10 seconds or press
again to hide the information. When the engine
has worked 14 hours, it will be indicated that
the filters must be cleaned, to remove the
indication, this button must be kept pressed.

PRACTICAL TIPS:

 It is recommended to keep the filters clean,
grease and dirt in the filters decreases the
efficiency of the engine and increases its
energy consumption.
 Adjust the extraction speed according to the
amount of smoke, working at high speeds with
little smoke consumes more energy.
CLEANING
 Disconnect the appliance from the mains and
allow it to cool before undertaking any cleaning
task.
 Clean the equipment with a damp cloth with a
few drops of washing-up liquid and then dry.
 Do not use solvents, or products with an acid or
base pH such as bleach, or abrasive products,
for cleaning the appliance.
 Do not let water or any other liquid get into the
air vents to avoid damage to the inner parts of
the appliance.
 Never submerge the appliance in water or any
other liquid or place it under running water.
 If the appliance is not maintained in good
cleaning condition, its surface can degrade and
inexorably affect the life of the appliance and
lead to a dangerous situation.
 Then dry all parts before its assembly and
storage.
CLEANING THE ALUMINUM FILTERS
 The filters can be cleaned by hand or with the
dishwasher. It is advisable to clean them
monthly.
 NOTE: Cleaning the filters in the dishwasher
may change colour slightly.
HAND CLEANING:
 Remove the filter as shown in the installation
section.
 Brush with a soft brush in a solution of warm
water and a small amount of liquid soap.
 Do not use liquid soap alone as it can damage
the filter.
 After cleaning, let the water drain and dry well.
DISHWASHER CLEANING:
 To clean the dishwasher, you must select a
program at 60ºC, place the filter vertically and
in the lower basket.
E N