MTD YARD-MAN YMGBV3100 Manual De Dueño página 9

ATTACHING AND REMOVING THE VACUUM BAG
Attaching
1. Attach the vacuum bag to the vacuum bag hook on
the blower/vacuum tube (Fig. 3).
2. Slide the vacuum bag tube over the debris exhaust
tube on the housing. Push the tube until the latching
tabs on both sides click into place, securing the bag
on the unit (Fig. 4).
Latching Tabs
Removing
1. Press the latching tabs on both sides of the vacuum
bag tube and pull the vacuum bag down from the
unit (Fig. 5).
2. Detach the vacuum bag from the vacuum bag hook.
PRESS IN
ASSEMBLY INSTRUCTIONS
Vacuum Bag Hook
Fig. 3
Debris Exhaust Tube
Vacuum Bag Tube
Vacuum Bag
Zipper
Fig. 4
Latching Tabs
PRESS IN
Fig. 5
INSTALLING THE SHOULDER HARNESS (Optional)
WARNING:
never attempt to start the unit when
standing, when the unit is clipped to the
shoulder strap. Always follow the starting
procedures as described in the Starting/
Stopping Instructions section.
The shoulder strap is an optional accessory.
1. Push the strap through the center of the buckle.
2. Pull the strap over the cross bar and down through
the slot in the buckle (Fig. 6).
3. Snap the clip on to the support fittings on the front
or back of the handle. Clip to the front portion of the
handle when using the unit as a blower, and clip to
the back portion of the handle when using the unit as
a vacuum (Fig. 7).
Attach Here for
Blowing
4. While standing in the operating position adjust length
to fit the operator's size. Pull tab to lengthen, pull
strap to shorten (Fig 8).
To avoid serious
personal injury,
Clip
Fig. 6
Attach Here for
Vacuuming
Fig. 7
Fig. 8
9