Technical Data - Clatronic SPM 3753 Manual De Instrucciones

1. Press the switch in order to turn the appliance on.
2. First use a brush to clean the shoes, i.e. to remove dirt
and dust from the surface of the shoes.
3. To apply shoe polish to the shoes, gently press the shoe
against the ball located in the closure of the polishing
dispenser.
WARNING:
• Always pull the plug before cleaning and maintenance.
• Wait until the appliance has cooled down.
• Never immerse the appliance in water. It could result in an elec-
tric shock or fire.
CAUTION:
• Do not use any wire brush or other abrasive objects.
• Do not use any acidic or abrasive detergents.
Debris Collecting Mat
Then remove the mat. Then clean it by knocking it out or
vacuuming it.
Bracket, Polishing Dispenser, Closure
Clean these components in a rinsing bath. Allow the compo-
nents to dry completely before refitting them.
Housing
Use a slightly damp cloth to clean the housing.
Replacing the Brushes
In order to replace the brushes, proceed as follows:
1. Use a screwdriver to
loosen the screws (see
adjacent figure).
2. Slide the brushes off the
driving shaft.
3. Attach the new brushes by
applying the same order in reverse.
SPM3753_IM
4. Use one of the two brushes provided for polishing the
5. Use the
Cleaning / Maintenance
Problem Possible Cause
The
appliance
is not
working.
Model:.....................................................................SPM 3753
Power supply:....................................................230 V~, 50 Hz
Power consumption: .......................................................90 W
Protection class: .....................................................................
Net weight: ....................................................... approx. 4.0 kg
The right to make technical and design modifi cations in
the course of continuous product development remains
reserved.
This appliance has been tested according to all relevant
current CE guidelines, such as electromagnetic compatibility
and low voltage directives, and is manufactured according
to the latest safety regulations.
shoes.
NOTE:
Make sure to always use one polishing brush for light
and the other one for dark shoes.
switch to turn the appliance off.
Troubleshooting
The appliance has
no power supply.
The appliance is
defective.
The overheating
protection has been
activated. The motor
is too hot.

Technical Data

Remedy
Check the socket with
another appliance.
Plug in the mains plug
correctly.
Check the main circuit
breaker.
Contact our service or
a repair centre.
Let the appliance
cool down for at least
15 minutes before
switching it on again.
27
21.01.20