Mi-T-M GEN-12000-1MHE Manual Del Operador página 21

COnTROlS
CABLE SIZE:
Equipment damage can result from low voltage. Therefore, to prevent
excessive voltage drop between the generator and the equipment,
the cable should be of adequate gauge for the length used. The cable
selection chart gives the maximum cable lengths for various gauges of
wire which can adequately carry the loads shown.
CURRENT LOAD IN WATTS
IN AMPS 120 vOLTS
2.5 300
5 600
7.5 900
10 1200
15 1800
20 2400
25 3000
30 3600
40 4800
ELECTRIC MOTOR LOADS:
It is characteristic of common electric motors in normal operation to draw
up to six times their running current while starting. This table may be
used to estimate the watts required to start "CODE G" electric motors.
CauTIOn: If an eleCTRIC mOTOR faIlS TO STaRT OR
ReaCH RunnInG SPeed, TuRn Off THe
aPPlIanCe OR TOOl ImmedIaTely TO aVOId
equIPmenT damaGe. alWayS CHeCk THe
RequIRemenTS Of THe TOOl OR aPPlIanCe
beInG uSed COmPaRed TO THe RaTed OuTPuT
Of THe GeneRaTOR.
MOTOR (H.P.) RUNNING WATTS
1/8
1/6
1/4
1/3
1/2
3/4
1
Operator's Manual
Operating the Generator
240 vOLTS #8 WIRE
600
1200
1800
2400
3600
4800 175
6000 150
7200 125
9600 90
REPULSION INDUCTION
275
275
400
450
600
850
1100
MAXIMUM CABLE LENGTH (FEET)
#10 WIRE #12 WIRE
1000 600
500 300
350 200
250 150
150 100
125 75
100 60
65
WATTS REQUIRED TO START MOTOR
CAPACITOR
600
600
850
975
1300
1900
2500
#14 WIRE #16 WIRE
375 250
200 125
125 100
100 50
65
50
SPLIT PHASE
850 1200
850 2050
1050 2400
1350 2700
1800 3600
2600
3300
21