Adjusting The Depth Skid; Adjusting The Support Wheels; Cleaning The Tiller; Maintaining The Gear Box - Texas HMH 5500 Manual De Instrucciones

Adjusting the depth skid

The depth skid can be adjusting for tilling in three different depths. The deeper the depth skid
sits in the soil, the deeper the tilling blades will work and the slower the machine will
advance. The right cultivating depth will lighten your workload. The correct tilling depth
depends on the soil, and we recommend you make several attempts to see how deep the
depth skid should be so that you can work optimally in your soil.
To adjust the depth skid, pull it backwards and up till the preferred height is found. Place the
depth skid vertically, and it will fall into a notch. The depth skid can be adjusted to various
tilling depths. The deeper into the ground the depth skid goes, the deeper the tiller will work.
The right setting depends on the soil.
See figure 7

Adjusting the support wheels

The support wheels are mounted on the tiller. They can be adjusted to the required height by
pulling the lock handle and moving the ring up or down.
The wheel ring can be used to stabilise the machine when tilling and also help to
prevent the machine falling into soft soil.
See figure 8

Cleaning the tiller

The tiller should be cleaned after use. Use your garden hose and wash off soil and dirt. Clean
the rotor shaft of any grass, etc. The chassis number should only be cleaned with a moist
cloth otherwise it may be damaged. Avoid using a high pressure cleaner for cleaning.

Maintaining the gear box

The gear box on the tiller is lubricated at the factory with 0.2 litre TEXACO Multifak EP0 oil. It
is not necessary to renew the oil.

Engine

The engine is delivered without oil and fuel.
Remember to fill the engine with engine oil before starting.
Follow the guidelines in the user manual for correct use and maintenance of the engine.

Storage

Follow the procedure below when the machine is to be unused for a long period. This will
ensure the machine has a long service life.
Use your garden hose to wash off any soil and dirt. Clean the rotor shaft of any grass, etc.
The chassis number should only be cleaned with a moist cloth otherwise it may be damaged.
Avoid using a high pressure cleaner for cleaning. Clean the body with a damp cloth so all the
surfaces are clean. The surface must be wiped with an oily cloth to prevent rust.
13