CHEF-BUILT CCB-2000 Manual De Instrucciones página 5

17. Do not use water jet to clean this appliance
18. Ensure the jar coupler and motor coupler are aligned and engaged
before operating. If unable to engage, remove the jar and shake
contents, then try again.
19. The jar coupler and motor coupler may be hot after operating.
Do not touch.
20. The use of ear protection is recommended during extended
operating periods.
21. This appliance must be positioned so that the plug is accessible.
22. Always use HIGH (=) speed for crushing ice.
23. DO NOT OPERATE IF JAR OVERFLOWS. If the jar overflows
during blending, there is too much liquid/ingredients in the jar.
Press the STOP button, remove liquid/ingredients to below MAX
FILL line, and continue blending.
24. Do not use carbonated liquids in the jar or any blending container.
Use of carbonated liquids in the jar or any blending container may
result in injury.
25. Do not blend oil or oil-based products such as peanut butter for
more than 5 minutes.
26. Never remove blender jar from the base unit until the blade and
coupling have completely stopped.
27. Check to make sure the ON/OFF (I/O) switch on the side of the
motor base is in the OFF (O) position before plugging cord into the
electric outlet.
28. To disconnect, always press the ON/OFF (I/O) switch to OFF (O)
before unplugging from the electric outlet.
29. Do not use this appliance for other than intended use.
30. Do not leave this appliance ON (I) overnight or for prolonged
periods of non-use.
31. Do not leave this appliance unattended when it is ON (I).
SAVE THESE INSTRUCTIONS
FOR COMMERCIAL USE ONLY
SO-315234_18062 Chef-Built_Bar Blender 48oz CCB-2000_Sensio_IM_R6.indd 3
3
2018-08-10 3:36 PM