How To Use - Russell Hobbs KE7900 Serie Instrucciones

How to Use

This appliance is for household use only.
BEFORE USING YOUR KETTLE
• Remove all packing materials, any stickers and the plastic band around
the power plug.
• To register your product, go to www.prodprotect.com/russellhobbs.
• Wash all parts as instructed in CARE AND CLEANING section.
• Select a level surface where this unit is to be used allowing enough space
for steam to escape without damage to counters, cabinets and walls.
• Fill kettle to maximum fill line with cold water. Bring to boil, discard and
repeat. Kettle is now ready for use.
PARTS
1. Filter (part no. KE7900-01 )
2. Lid
3. Lid release
FILLING
1. Open the lid.
2. Fill with at least 1 cup of water, but not above max.
3. Close the lid. Always close the lid when boiling the kettle.
USING YOUR KETTLE
1. Put the stand on a stable, level surface.
2. Plug the stand into the wall socket.
3. Put the kettle on the stand.
Move the switch to I.
4.
5. The light will come on and the kettle will start to heat up.
6. When the water boils the kettle will switch off.
To switch off manually, move the switch to O, or simply lift the kettle off
7.
the stand.
GENERAL
When you lift the kettle, you may see moisture on the stand. Don't worry –
it's the steam used to switch off automatically, which then condenses and
escapes via vents under the kettle.
BOIL DRY PROTECTION
• This will shorten the life of the element. A boil-dry cut-out will switch the
kettle off.
• You must then remove the kettle from its stand to reset the cut-out.
• Sit the kettle on the work surface till it's cold.
4. On/Off Switch
5. Stand
5