Maintenance - LG WM2140CW El Manual Del Propietario

M aintenance
❋ Before cleaning the washer interior, unplug the electrical power cord to avoid electrical
shock to avoid electrical shock hazards.
❋ When disposing of the appliance, cut off the mains cable, and destroy the plug Disable the
door lock to prevent young children being trapped inside.
The water inlet filter
- " " error message will blink on the control panel when water does not enter the
detergent drawer.
- If your water is very hard or contains traces of lime deposit, the water inlet filter may
become clogged.
It is therefore a good idea to clean it from time to time.
The drain pump filter
❋ The drain filter collects threads and small objects left in the laundry.
Check regularly that the filter is clean to ensure smooth running of your machine.
!
CAUTION First drain using the drain and then open the pump filter to remove whatever
any threads or objects.
Be careful when draining if the water is hot.
❋ Allow the water to cool down before cleaning the drain pump filter.
1. Open the lower
cover cap ( ) by
using a finger. Turn
the drain plug ( ) to
pull out the hose.
20
1. Turn off the
water tap.
3. Clean the filter
using a hard
bristle brush.
2. Unplug the drain plug ( ),
allowing the water to flow out. At
this time use a vessel to prevent
water flowing on to the floor.
When water does not flow any
more, turn the pump filter ( )
open to the left.
or
or
3. Remove any foreign material
from the pump filter ( ). After
cleaning, turn the pump filter
( ) clockwise and insert the
drain plug (
place. close the lower cover
cap.
3
2
2. Unscrew the
water inlet
hose.
4. Tighten up
the inlet
hose.
)to the original
3
2