Overview; Setup; Installation; Sound-Control - EuroLite LCD-4 MP/S Manual Del Usuario

4.2 Overview

Overview on the control elements
1) POWER SWITCH
2) KANAL-LEDs
3) CHANNEL FADERS
4) FLASH-BUTTONS
5) MODE LEDs
6) MODE SELECT-BUTTON
7) PROG SELECT-BUTTON
8) DISPLAY
9) FADE TIME-FADER
10) DIMMER
11) AUDIO-FADER
12) SPEED-FADER
13) STANDBY-BUTTON
14) FULL ON-BUTTON
15) TAP SYNC-BUTTON

5. SETUP

5.1 Installation

Install the device on a plane surface or install it in rack.
This device is built for 483 mm racks (19"). This rack should be a double-door rack where front panel and
rear panel can be opened. The rack should be provided with a cooling fan. When mounting the device into
the rack, please make sure that there is enough space around the device so that the heated air can be
passed on. Steady overheating will damage your device. You can fix the device with four screws M6 in the
rack. If several devices are to be installed, make sure that you leave 1 unit (1 u) space between the devices.

5.2 Sound-control

The sound-control works via the built-in microphone or via the sound input socket.
Connect the sound-signal from the mixer (e.g. Master 2) with the RCA-socket on the rear panel (input
sensitivity 0.1 V - 1 V).
16/36 00026201.DOC, Version 2.3