Troy-Bilt STORM 2840 Manual Del Operador página 18

Wheels
At least once a season, remove both wheels. Clean and coat the
axles with a multipurpose automotive grease before reinstalling
wheels.
Auger Shaft
At least once a season, remove the shear pins from the auger
shaft. Spray lubricant inside the shaft and around the spacers and
the flange bearings found at either end of the shaft.
See Fig. 6-3.
18 s 6 — M
ectiOn aintenance
Figure 6-3
& a
djustMents
Adjustments
Shift Cable
If the full range of speeds (forward and reverse) cannot be
achieved, refer to the figures to the right and adjust the shift
cable as follows:
1. Place the shift lever in the fastest forward speed position.
2. Loosen the hex nut on the shift cable index bracket. See
Fig. 6-4.
Figure 6-4
3. Pivot the bracket downward to take up slack in the cable.
4. Retighten the hex nut.
Auger Control
Refer to the Assembly and Set-up section for instructions on
adjusting the auger control cable.
Chute Assembly
Refer to the Assembly and Set-up section for instructions on
adjusting the chute assembly.
Skid Shoes
Refer to the Assembly and Set-up section for instructions on
adjusting the skid shoes.