How Your Humidifier Works - Essick Air ED11 Serie Manual De Cuidados Y Uso Del Propietario

HOW YOUR HUMIDIFIER WORKS

Dry air is drawn into the humidifier through the back and moisturized as it passes
through the evaporative wick.
It is then fanned out into the room.
1. Chassis/Power Pack
(motor and fan assembly)
2. Evaporative wick
3. Water reservoir
4. Dry room air intake
5. Moist air output
CAUTION: Do NOT position the unit
directly in front of a hot air duct or radiator. Do NOT place on soft carpet.
NOTE: Humidifier must be level for proper operation, and to prevent leakage.
ASSEMBLY, CONTROLS & OPERATION
1) Remove the packing inserts from the top of the humidifier.
2) Lift off the chassis/power pack and then remove the humidifier tank/cabinet from
the carton.
3) Remove any wrapping from the evaporative wick and all of the remaining
packaging materials from the cabinet. Check to see that you have all of the
following items removed from the boxes accessory kit and cabinet before
discarding the packaging:
● Caster kit ● Float (Styrofoam)/Float rod ● Retainer (key for float rod)
● Reservoir float assembly ● Wick ● Manual
CASTERS
4) Turn the emptied cabinet upside
down. Insert each caster stem
into the four caster holes on each
corner of the humidifier bottom.
The casters should fit snugly and
be inserted until the stem
shoulder reaches the cabinet
surface. Turn the cabinet right
side up.
FLOAT AND WICK INSTALLATION
5) Before installing the wick, install
the float rod by placing the white
Styrofoam portion into the recess
in the bottom of the cabinet. Then
place the float retainer loop over
the float rod spindle. Slide the clip
end of the retainer onto the
extension molded into the plastic
ledge until it locks into place. See illustration at right.
6) Install the 1041 wick into the unit with the
mounting rib on the top edge that hooks
over a rib at the back inside of the cabinet.
See inset on illustration at left.
4