Hinkley ARTISTE Manual De Instrucciones página 13

INSTALLING THE LIGHT KIT AND GLASS SHADE
Mounting plate
Light Wires
Fig. 1
NOTE: Be sure the power is off before installing.
1
Remove one of the three screws on the mounting hub
located on the fan motor. Loosen the other 2 screws. (Do not
remove) (Fig. 1)
2
Pass the light wires through the center hole of the mounting
plate.
3
Place the key holes on the mounting plate over the 2 screws
previously loosened, turn the mounting plate until it locks in
place at the narrow section of the key holes. Secure by
tightening the 2 screws previously loosened and the one
previously removed.
4 Remove one of the three screws on the mounting plate
located on the fan motor. Loosen the other 2 screws. (Do not
remove) (Fig. 2)
Mounting Hub
(bottom of motor)
Screws
5
Wire connectors
Light Kit
Glass shade
Fig. 2
5
While holding the LED light kit under your fan, make the
polarized plug connections: (Fig. 2)
- Red to white
- Black to black
6 Tuck connections neatly into mounting plate. Place the key
holes on the light kit over the 2 screws previously loosened,
turn the light kit until it locks in place at the narrow section of
the key holes. Secure by tightening the 2 screws previously
loosened and the one previously removed.
7
Raise the glass shade against the LED light kit and turn
clockwise until snug, DO NOT OVERTIGHTEN.
8
Restore power and your light kit is ready for operation.
Mounting plate
Screws
©2019 Hinkley Lighting, Inc. | hinkley.com | 11