Hanging The Fan - Hinkley 60 GRANDER Manual De Instrucciones

HANGING THE FAN

Remove two yoke cover screws from the yoke cover on top
1
of the fan motor assembly. Take off the yoke cover. (Fig. 1)
Remove ball from downrod by loosening set screw in the
2
side of the ball. Slide ball down and remove ball pin; remove
ball. (Fig. 2)
Carefully support fan body (motor) in its styrofoam packing
3
with the mounting collar (where the wires come out) facing
upward.
Loosen the two security set screws and remove the downrod
4
pin and retaining clip from the coupling on top of the motor
assembly. (Fig. 3)
Carefully feed the electrical lead wires from the fan through
5
the downrod. Thread downrod into coupler until holes align.
Insert downrod pin through holes in mounting collar and
downrod; clip cotter pin through small hole in end of
downrod pin to hold downrod in place.
6 Tighten security set screws against downrod using a large
flat blade screwdriver to ensure a tight fit against downrod.
Tighten nuts against mounting collar.
06 | hinkley.com
Fig. 1
Cross pin
Hanger
ball
Set Screw
Fig. 2
Hook-up
(3) Wires
Downrod
Mounting Collar
Cotter Pin
Top of
Fan Body
Fig. 3
Screws
Downrod
Security Screws
Downrod Pin