Description Of Buttons And Switches; Getting Started; Important Guidelines - VWR Hotplate W10 Manual De Instrucciones

Description of Buttons and Switches

Instruction Manual (GB)

Getting Started

Turn the unit ON by pressing the upper part of the power switch; the power switch shows
green light and the display shows actual temperature.
To change the desired temperature, see instructions 1-2-3 in the figure above.
If you press longer than 3 seconds and the display shows P5 then reset the unit by pressing
the power switch OFF and then ON. Start at 1 again, see above.

Important Guidelines

First turn the unit OFF. Then disconnect the power cord first from the mains supply and then
from the unit.
Please observe that the heated area can be hot.
Service and repair should only be made by an authorized technician.
4 (28)