Hardware Installation; Osd Settings - Velleman CAMTVI17 Manual Del Usuario

 Damage caused by disregard of certain guidelines in this manual is not
covered by the warranty and the dealer will not accept responsibility for
any ensuing defects or problems.
 Keep this device away from extreme heat.
 Protect this device from shocks and abuse. Avoid brute force when
operating the device.
 Do not use this product to violate privacy laws or perform other illegal
activities.
4.

Hardware installation

1. Choose a location for the camera, keeping following guidelines in mind:
do not install the camera in locations where extremely high or low
o
temperatures or excessive vibrations may occur.
avoid mounting the camera near high electro-magnetic fields.
o
do not aim the camera at the sun or other extremely bright objects
o
or reflections (e.g. metal doors).
Take the base as a template and drill the necessary mounting holes. If
necessary, drill a hole for routing the cables. Insert a nylon plug in each
hole.
2. Loosen the joint lock for the bracket using a hex wrench.
3. Fix the bracket using the included screws. Adjust the camera lens and
aim it toward the surveillance area. Lock the bracket using a hex
wrench.
5.

OSD Settings

There is a small joystick in the camera cable that allows you to adjust the
settings of the camera using an on-screen display (OSD).
In the OSD menu:
 NEXT/BACK: select this option and press the middle button to go to the
next/previous page of options in the menu.
 RETURN: select this option and press the middle button to return to the
previous level in the menu.
 EXIT: select this option and press the middle button to leave the OSD
menu without saving the settings.
V. 01 – 24/10/2018
CAMTVI17/CAMTVI17Z
 Press the middle button to access the menu, or
to select an option.
 Press the up and down buttons to move up and
down in the menu.
 Press the left and right buttons to modify the
menu parameters.
3 ©Velleman nv