Publicidad
Idiomas disponibles
Idiomas disponibles
CAMTVI7N3/CAMTVI7WN3/CAMTVI8N3/CAMTVI8WN3
Use the mounting plate to determine the position of the mounting holes.
Drill the holes.
Guide the power and video cable through one of the cable slots and fix
the mounting plate on the ceiling or wall with the four screws.
Position the positioning ring over the lens enclosure onto the mounting
plate and then fix the ensemble by screwing the fixation ring onto the
mounting plate. Make sure the fixation ring is not screwed too tight to
leave the option open to position the lens into the direction of the
desired field of operation.
Connect the two wires for an analogue PAL signal; leave them
unconnected for a HD 1080P TVI signal.
Connect the video connector to a monitor (not incl.) or a sequential
switcher/quad splitter (not incl.) in case of multiple domes.
Connect the power connector to a 12 VDC power supply (not incl.).
Set up the desired field of observation by adjusting the position of the
lens enclosure in the positioning ring.
For the CAMTVI8(W)N3, manually adjust the zoom and focus with their
screws. The location of the screws can be determined by looking at the
position of the light sensor.
Tighten the fixation ring to secure the camera's position.
7.
OSD Settings
There is a small joystick in the camera cable that allows you to adjust the
settings of the camera using an on-screen display (OSD).
In the OSD menu:
NEXT/BACK: select this option and press the middle button to go to the
next/previous page of options in the menu.
RETURN: select this option and press the middle button to return to the
previous level in the menu.
EXIT: select this option and press the middle button to leave the OSD
menu without saving the settings.
SAVE ALL: select this option and press the middle button to save all
settings.
CAMERA RESET: select this option and press the middle button to reset
the camera to the factory defaults.
The OSD menu settings are described in detail below.
V. 01 – 04/07/2019
Press the middle button to access the menu, or
to select an option.
Press the up and down buttons to move up and
down in the menu.
Press the left and right buttons to modify the
menu parameters.
5
©Velleman nv
Publicidad
