Storing Channels in Memory (Automatic Method)
. Press the MENU button to display the menu.
Press the ▲ or ▼ buttons to select "Channel", then press the ENTER button.
2. Press the ▲ or ▼ buttons to select "Auto Program", then press the ENTER button.
3. Press the ▲ or ▼ buttons to select the antenna connection, then press the
ENTER button.
Air: "Air" antenna signal. / Cable: "Cable" antenna signal. /
Air+Cable: "Air" and "Cable" antenna signals.
4. When selecting the Cable TV system: Press the ENTER button to start the auto
program. By default, the cable TV system is set to "STD". If you want to select
another type of cable system, press the ▲ or ▼ button to select "STD", "HRC" or
"IRC".
STD, HRC and IRC identify various types of cable TV systems. Contact your
local cable company to identify the type of cable system that exists in your
particular area. At this point the signal source has been selected.
Press the ENTER button to start the auto program.
To stop the search before it has finished, press the ENTER button with stop
selected.
. After all the available channels are stored, the "Auto Program" menu reappears.
Press the ExIT button to exit.
Alternately, you can press the AUTO PROG. button on the remote control to bring
up the Auto Program menu.
English - 6
TV
Channel
Antenna
: Air
Auto Program
Clear Scrambled Channel
Channel List
Name
Fine Tune
Signal Strength
LNA
: On
Move
Enter
Move
Enter
TV
Channel
Select the antennas to memorize.
Start
Air
Start
Cable
Start
Air+Cable
Move
Enter
Move
Enter
TV
Auto Program
Selects the cable system.
Analog
STD
Start
HRC
IRC
Digital
STD
HRC
IRC
Move
Enter
Move
Enter
Auto Program
Auto Program in Progress.
Cable Channel 0
Stop
Enter
Plug & Play
Auto Program is completed.
6 Channels were memorized.
Air : 6, Cable : 0.
OK
Enter
►
►
►
►
►
►
►
►
Return
Return
Return
Return
Return
Return
0%
Return
Return