Reliable ARIA 100SP Manual De Instrucciones página 15

Place the pressing cushion under the waistband and press. Rotate skirt until the
entire waistband is pressed.
Slip the skirt over the board. Arrange the pleats. Press. Pleats may need to be
pinned to the ironing board cover. Do not use plastic head pins when using the
press. Rotate the skirt until all pleats are pressed.
JACKET
Sleeves without creases- Fold the sleeve on the seam line and place the seam
line flat on the board. Allow the top edge of the sleeve to hang off the edge of the
board. Press.
Lapels- Place lapels flat, diagonally on the ironing board. Press. Use the ironing
cushion if needed.
TIES AND RIBBONS
Place the tie lengthwise on the board. Press. You can also place them horizontally
on the board and close the press then pull the tie or ribbon through it.
EMBROIDERY ITEMS
Place the garment face down on the ironing board to reduce wear and prevent
damage.
If needed, place a towel over the garment then press. This will protect stitching,
rhinestones, etc.
CAUTION: When ironing embroidered, stitched items or garments with rhinestones,
sample an area to see if the steam or heat will affect the area and proceed with
caution.
STORING AND MAINTENANCE
CAUTION: Prior to storing or providing maintenance to your steam press, isolate
the unit by removing the cord from the power socket and avoid immersing the unit
in water.
1. Water may be left in water tank reservoir; however, it is recommended that if
the machine will be stored for a long period of time, any left over water in the
unit should be drained by pressing the steam burst button before the end of
use until the water tank is emptied.
2. Wait approximately 30 minutes for the press to cool down before storing.
12