Mopar 4280359 Manual Del Usuario página 8

8
21. Install the TIPM (1) onto it's bracket. Make sure the
TIPM's upper retaining tabs (2) fully engage.
22. Install the cover back on to TIPM (1).
23. Obtain the kit supplied hood ajar switch plunger (1)
and rivet. Locate the mounting holes on the front pas­
senger side of the hood and position the plunger (1)
to the hood as shown.
24. Lower the hood slightly and check for proper align­
ment between the plunger (1) and hood ajar switch.
25. Once properly aligned, install the rivet to secure the
hood ajar switch plunger.
WIRELESS CONTROL MODULE (WCM) AND REMOTE START ANTENNA INSTALLATION
WARNING: To avoid serious or fatal injury on vehicles equipped with airbags, disable the Supplemental Restraint
System (SRS) before attempting any steering wheel, steering column, airbag, seat belt tensioner, impact sensor
or instrument panel component diagnosis or service. Disconnect and isolate the battery negative (ground) ca­
ble, then wait two minutes for the system capacitor to discharge before performing further diagnosis or service.
This is the only sure way to disable the SRS. Failure to take the proper precautions could result in accidental
airbag deployment.
Jan 19, 2011
4280359
K6861247