Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Drive Control
Electric Starter
Push Key
Recoil Starter
Side Discharge
Chute
Blade Control
The blade control is attached to the upper handle of the mower. Depress and
squeeze it against the upper handle to operate the unit. Release it to stop engine
and blade.
This blade control is a safety device. Never attempt to bypass its operation.
Drive Control
The drive control is located on top of the upper handle and is used to engage the
drive. Squeeze it against the upper handle to engage the drive; release it to slow
down or stop mower from propelling.
Cutting Height Adjustment Lever
One adjustment lever is located on the right rear wheel and one is located on the
right front wheel. Both levers have to be at the same position to ensure a uniform
cut. To adjust the cutting height, refer to the Assembly Section.
Side Discharge Cover
Your mower is shipped as a mulcher. To discharge the grass clippings to the side
instead, follow the instructions in the Assembly section to attach the side discharge
cover.
Trail Shield
The trail shield is attached to the rear of the mower and is there to protect the
operator from flying debris. Do not use the mower unless the shield is fully
functional and in place.
Craftsman Lawn Mowers conform to the safety standard of the American National Standards Institute (ANSI).

OPERATION

Cutting Height
Adjustment
Lever
Trail Shield
(Not Shown)
Battery
Compartment
Oil Fill Cap/Dipstick
WARNING
Meets ANSI Safety Standards
Blade Control
Mulch Cover
Figure 13
Deck Wash
Your mower's deck is equipped with a water port on its surface as part of its deck
wash system. Use the deck wash to rinse grass clippings from the deck's underside.
Mulch Cover
The mulch cover is used for mulching purposes. Instead of collecting the grass
clippings in a grass catcher or using the side discharge chute, some mower models
have the option of recirculating the clippings back to the lawn. This is called
mulching.
Keep hands and feet away from the chute area on cutting deck. Refer to
warning label on the unit.
Recoil Starter
The recoil starter is attached to the right upper handle. Stand behind the unit and
pull the recoil starter rope to start the unit.
Oil Fill Cap/Dipstick
Refer to the Engine Operator's Manual packed with your mower for detailed oil
filling, checking and changing instructions.
Electric Starter Push Key
The electric starter push key is located on the right side of the upper handle. It is
both a removable key and push button and is only provided on electric start models.
11
Battery
Charger
Deck Wash
Cutting Height
Adjustment
Lever
WARNING

Publicidad

Capítulos

Tabla de contenido

Solución de problemas

loading

Tabla de contenido