Assembly/Pre-Operation - Craftsman 960420223 Manual Del Operador

(1) Small
Retainer Springs
(5) Large
Retainer Springs
(1) Anti-Sway Bar
Keys
(2) Keys
Your new tractor has been assembled at the factory with the exception of those parts left
unassembled for shipping purposes.
TOOLS REQUIRED FOR ASSEMBLY
A socket wrench set will make assembly
easier. Standard wrench sizes are listed.
(2) 7/16" wrenches
(1) 1/2" wrench
(1) 3/4" wrench
(1) 3/4" socket w/drive ratchet
(1) 9/16" wrench
When right or left hand is mentioned in this
manual, it means when you are in the operating
position (seated behind the steering wheel).
UNASSEMBLED PARTS
Mower
(2) Rear
Lift Link
Assemblies
(1) Front
Lift Link
Assembly
If Equipped
(1) 3/4 O.D.
Washers
(1) Quick Connect

ASSEMBLY/PRE-OPERATION

Utility knife
Tire pressure gauge
Pliers
Flashlight
(1) Shoulder Bolt
(1) Small Retainer
Springs
(1) Oil Drain Tube
TO REMOVE TRACTOR FROM
CARTON
UNPACK CARTON
• Remove all accessible loose parts and
parts cartons from carton.
• Cut along dotted lines on all four panels
of carton. Remove end panels and lay
side panels flat.
• Check for any additional loose parts or
cartons and remove.
BEFORE REMOVING TRACTOR
FROM SKID
7
Mower Front Wheel
(1) Wheel
*Installed by Dealer
Slope Sheet
(1) 1-1/4 O.D.
Washer
(1) 3/8-16
Locknut
*Brush Guard Kit