2. INTRODUCTION
Congratulations! You are the owner of a genuine ECLER professional equipment. The NUO2 has been carefully
designed in collaboration with leading dj performers and advance music producers, developed with the highest
quality components, and manufactured in-house (Barcelona-Spain) under strict quality controls.
The NUO2 is a three-channel stereo mixer with capacity for 8 separate sound sources.
Due to its robustness and format, the NUO2 is mainly dedicated to professional mixing applications (club,
homestudio), or anywhere where a compact sized mixer is required.
3. INSTALLATION
The first thing to take into consideration when placing your NUO2 is your comfort and an easy access to all the
connections. The NUO2 is basically conceived as a tabletop mixer and its usual placement will be between two
vinyls or CD players. The mixer has a 14.57'' (37cm) depth and 6.3'' (16cm) width format. The optional metallic side
profiles kit allows you to firmly fix your mixer to the surface over which it is placed or over its own profiles (Fig.1).
These profiles also allow to tilt the mixer's position for an easier operation.
Because of the high gain of the PHONO and MICROPHONE inputs, always try to place the mixer as far away as
possible from noise sources (dimmers, engines, etc.) and mains wires. For the very same reason, and under any
circumstance, you should never remove the unit's metallic cover.
The power consumption of the NUO2 is very low, so they do not need any cooling, but you should avoid extreme
temperatures and the atmosphere should be as dry and dust free as possible.
The NUO2 operates now with a new universal input power supply "Switching Power Supply" and can perfectly
works without any internal modification from 90V to 264V – 47 to 63Hz. Make sure that the mains-wire is far away
from the signal-cables in order to avoid any possible audio hum.
In order to protect the unit from an eventual electrical overload it carries a T 500mA fuse. Should it ever blow up,
unplug the unit from mains and replace it with an identical one. If the new fuse blows again contact immediately
with our authorized technical service.
ATTENTION: NEVER SHORT-CIRCUIT THE SECURITY PATH NOR USE A HIGHER VALUE FUSE.
CAUTION: Fuse substitutions have to be performed by a qualified technician.
5