LG 65QNED90SPA Manual Del Usuario página 17

IR Blaster
Control the set-top box (cable/satellite/IP/OTT), Blu-ray/DVD player, soundbar, game consoles, etc., using the IR
Blaster. (Depending upon country) (Depending upon model)
• Connect the IR Blaster cable to the TV's IR Blaster port.
Note
• Place both ends (one or two) of the IR Blaster in front of the external device as shown in the picture below.
• Use universal control settings to control the device. Go to
• Secure the IR Blaster with the 3M tape provided.
External
Supported external devices are: Blu-ray player, HD receivers, DVD players, VCRs, audio systems, USB storage
devices, PC, gaming devices, and other external devices.
Devices
• If you record a TV program on a Blu-ray/DVD recorder or VCR, make sure to connect the TV signal input
Note
• The external device connections shown may differ slightly from illustrations in a manual.
• Connect external devices to the TV regardless about the order of the TV port.
• If you connect a gaming device to the TV, use the cable supplied with the gaming device.
• Refer to the external equipment's manual for operating instructions.
• In PC mode, there may be noise associated with the resolution, vertical pattern, contrast or brightness. If
• Some USB Hubs may not work. If a USB device connected through a USB Hub is not detected, connect it
• When connecting via a wired LAN, it is recommended to use a CAT 7 cable.
[External Devices] → [Universal Control Settings].
cable to the TV through a DVD recorder or VCR. For more information about recording, refer to the manual
provided with the connected device.
noise is present, change the PC output to another resolution, change the refresh rate to another rate or
adjust the brightness and contrast on the [Picture] menu until the picture is clear. Depending upon the
graphics card, some resolution settings may not allow the image to be positioned on the screen properly.
directly to the USB port on the TV.
→ → [General] → [Devices] →
17