Connection High Pressure Outlet; Connection To Water Supply - Interpump T Serie Manual De Instrucoes

5.1 HIGH PRESSURE CONNECTION
1 - Connect one end of the high pressure hose to the automatic gun (A) and the other end to
the OUTLET connection on the machine. Tighten firmly (B).
2 - Complete the assembly by coupling the extension to the gun/lance and tighten firmly (C).
5.2 - CONNECTION TO THE WATER SUPPLY
1- The maximum temperature of the inlet water must not exceed 60°C (140°F).
2- Connect the water supply to the INLET (D) port by means of a reinforced hose (min.15
bar/1,5 MPa/200 psi) with the internal diameter not less than 13mm (1/2")
3- Since the water flow decreases according to the length of the hose, make sure that the quan-
tity of water supplied to the machine is not less than the quantities indicated in the chart below.
4- The pressure of the inlet water must not exceed 10 bar, 1 MPa, 145 psi.
ATTENTION: The water supply which enters into the washer is not drinkable.
FLOW RATE OF
T-TX SERIES
WATER SUPPLY
MODEL L/min.
11
T 8-90
13
TX 955.6
T 10-100
T 11-120
TX 10-130
15
TX 12-100
TX 12-140
TX 951
TX 14-120
TX 13-180
17
TX 956
TX 954
TX 15-150
TX 17-130
20
TX 957
TX 961
If the user wishes to power the washer by means of free suction, simply emerge the end of the
supply tube in the water to be suctioned. The maximum suction depth considered as the dis-
tance in height between the water surface and the pump varies between 1 m. and 3 m. (see
technical specifications table).
IMPORTANT
The water supplied to the machine must be clean. Running the unit without water, or with water
which is dirty, contains grit or corrosive liquids, causes serious damage to the machine.
G.P .M. USA
2.9
3.4
4
4.5
5.3
13