Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
TABLE OF CONTENTS
Section
Contents
1.0
2.0
3.0
4.0
5.0
6.0
7.0
8.0
9.0
10.0
11.0
12.0
13.0
14.0
15.0
16.0
17.0
18.0
19.0
20.0
21.0
22.0
23.0
24.0
25.0
26.0
27.0
1.0 GENERAL INFORMATION
This appliance is a high efficiency, unvented, flame effect gas heater. It
provides radiant and convected warmth both efficiently and safely
utilizing the latest type catalytic convertor burner technology. The
appliance does not require a flue system of any type as the catalytic
converter cleans the flue products to provide a complete combustion
system, which is intrinsically safe.
These heaters are fitted with a specially designed pilot utilizing an
oxygen depletion sensor (ODS) which responds to the amount of
oxygen available in the room and shuts the heater off before the oxygen
level drops below 18%. The pilot can be relit only when fresh air is
available. Refer to the Combustion and Ventilation Air section.
The appliance is designed to fit various types of situations as listed in
the Installation Requirements.
This appliance is factory set for operation on the gas type, and at the
pressure stated on the appliance rating plate.
On initial light up of a new appliance, the 'newness' will burn off within
the first few hours of operation. During this period some smoke may be
emitted from outlet grille, this should be no cause for concern.
Accordingly, the room should be well ventilated with all windows and
doors open during this period.
Read all these instructions before commencing installation.
All instructions must be handed to the user for safekeeping.
2.0 INVENTORY
QUANTITY
Page No.
2
2
2
2
3
3
4
5
3.0 APPLIANCE DATA
5
5
Gas Type
5
Gas inlet pressure Maximum
6
6
Regulator Pressure Setting
6
Max Energy Input
6
Min Energy Input
7
Pilot Energy Input
7
Burner (Manifold) Pressure
7
8
8
8
Main burner flow restrictor
8
Oxypilot
9
Gas Inlet Connection
9
Ignition
10
Spark Gap
10
Please see Data Plate affixed to appliance for current data.
11
This appliance is for use only with the gas type, and at the pressure
stated on the appliance Data Plate.
4.0 IMPORTANT SAFETY INFORMATION
IMPORTANT: READ AND UNDERSTAND THESE
INSTRUCTIONS COMPLETELY BEFORE INSTALLING OR
OPERATING YOUR UNVENTED ROOM HEATER.
STATE OF MASSACHUSETTS: THE INSTALLATION MUST BE MADE
BY A LICENSED PLUMBER OR GAS FITTER IN THE
COMMONWEALTH OF MASSACHUSETTS.
WARNING: FAILURE TO COMPLY WITH THE INSTALLATION
AND OPERATING INSTRUCTIONS PROVIDED IN THIS
DOCUMENT WILL RESULT IN AN IMPROPERLY INSTALLED
AND OPERATING APPLIANCE, VOIDING ITS WARRANTY.
ANY CHANGE TO THIS APPLIANCE AND/OR ITS
OPERATING CONTROLS IS DANGEROUS. IMPROPER
INSTALLATION OR USE OF THIS APPLIANCE CAN CAUSE
SERIOUS INJURY OR DEATH FROM FIRE, BURNS,
EXPLOSION OR CARBON MONOXIDE POISONING.
WARNING: FAILURE TO KEEP THE PRIMARY AIR
OPENING(S) OF THE BURNER(S) CLEAN MAY RESULT IN
SOOTING AND PROPERTY DAMAGE.
Carbon Monoxide Poisoning: Early signs of carbon monoxide
poisoning are similar to the flu with headaches, dizziness and/or
nausea. If you have these signs, obtain fresh air immediately. Turn off
the gas supply to the appliance and have it serviced by a qualified
professional, as it may not be operating correctly.
2
DESCRIPTION
1
Firebox, burner & curved rear frame assembly
1
Installation and operating instructions
1
Glass facia panel assembly
1
Screw and wall plug pack
1
Rubber grommet
1
Fitting template
1
Wall mounting plate
Natural Gas
10.5" w.c.
Minimum
6" w.c.
5" w.c.
8,870 BTU/hour
5,110 BTU/hour
560 BTU/hour
High
3.6" w.c. (+/-0.3" w.c.) Hot
3.5" w.c. (+/-0.3" w.c.) Cold
Low
1.2" w.c. (+/-0.3" w.c.) Hot
1.1" w.c. (+/-0.3" w.c.) Cold
Stereo 1.45mm (1/4" BSP)
SIT/Bray 9082
3/8" NPT at regulator
Piezo spark
1/8" - 3/16"
Publicidad
Capítulos
Tabla de contenido
Solución de problemas
