ClearSounds A600E Instrucciones De Uso página 6

Desk / Table Mounting
1. Plug the AC power adapter into the
jack on the back of the base,
then plug the AC adapter into a
standard electrical outlet or
surge protector.
NOTE: The adapter is required for the phone to work.
Installing Batteries Three AAA re-chargeable Ni-MH batteries
come with your phone. You must install the batteries before
using your phone.
1. Remove the battery compartment cover by
sliding it downwards.
2. Insert the new batteries. Be sure to
observe battery polarity as imprinted
on the inside of the compartment.
3. Replace the battery compartment cover by
sliding upward until it clicks into place.
NOTE: The batteries need to be replaced if they do
not recover their full storage capacity after recharging.
Check the battery icon on the LCD to see the battery charge
level.
When replacing the batteries, always use good quality Ni-MH
AAA re-chargeable batteries.
6 – ENGLISH
REAR OF BASE