Operation With Mfx - marklin 70393 Manual Del Usuario

CV Meaning
39 Slow movement
Medium fast movement
PoM*
Fast movement
Medium fast movement
with bouncing
Fast movement with
bouncing
Medium fast movement
with bouncing of Arm 1
Medium fast movement
with bouncing of Arm 2
40 Meaning Lighting
PoM*
41 Center setting for Arm 1
PoM*
42 Center setting for Arm 2
PoM*
*PoM programming can be done on the main track as long as it
is supported by the control device.
Values
0 (0)
1
2
3
4
5 only with 70411 /
70412 / 70413 / 70414
6 only with 70411 /
70412 / 70413 / 70414
0 - 15 (15) 0 light off
Dimming 0-15,
whereby 15 = 100%
brightness
0 - 255 Setting of the middle
position for the arm
on all signals
0 - 255 Only with 70411 /
70412 / 70413 / 70414
Setting of the middle
position for the 2nd
arm
Setting and Calculating Addresses Greater than 255 (DCC):
Example: Address 1044 -> 1044 : 256 = 4.078125. The value before
the decimal point (4) is entered in CV 9. The value after the
decimal point (0.078125) is multiplied by 256 0.078125 x 256 = 20.
The calculated value of 20 must be entered in CV 1.

Operation with mfx

mfx registration can be done with MM or DCC.The mode of ope-
ration that has been set by means of Dip Switch 10 is critical.
The mfx registration is initiated with the 60213/60214/60215 CS2
in > and with the 60216/60226 CS3 in the solenoid item
configuration by means of
Note about mfx registration with the CS2:
Selection possibility „Automatically assign solenoid item" at
„Setup" > > „Track".
If the check mark there is checked, the mfx registration is done
at the first open address in the CS2. If the check mark is not
checked, the mfx registration is done at the address actually
programmed on the decoder.
>"search for mfx item".
9