Greencut PP400L Manual De Instrucciones página 45

SWORD AND CHAIN
Install the sword and chain as follows:
• Disassemble the tensioner lock and remove the sprocket cover.
• Install the bar and slide it slowly towards the chain.
• Position the chain as shown in the drawing. (Make sure the saw teeth are counterclockwise.
• Install the sprocket cover on the pin, and turn the sprocket wheel. Make sure the tension block passes through
the hole in the bar.
• Tighten the tension wheel and hold the guide plate.
• Lift the bar and tighten the nuts.
• Turn the chain around the bar. If you feel you are too tense, please loosen the regulator.
Chain
Sword
Central hole
Sprocket
3-4 mm
45
EN
Tensor