Operating Instructions
Remote control
How to Insert the Batteries
Remove the battery cover according to the arrow direction.
Insert new batteries making sure that the (+) and (-) of
battery are matched correctly.
Reattach the cover by sliding it back into position.
Note:
Use 2 LR03 AAA(1.5volt) batteries. Do not use rechargeable batteries.
Replace batteries with new ones of the same type when the display
becomes dim.
If the replacement is done within 1 minute, the remote control
will keep original presetting.
How to Use
To operate the room air conditioner , aim
the remote control to the signal receptor.
The remote control will operate the air
conditioner at a distance of up to 23 feet
when pointing at signal receptor of indoor
unit.
Remote Control presetting
The remote control is NOT preset as Cooling
only or Heat Pump by manufacturer.
Each time after the remote control replaces batteries
or is energized, the Cooling indicator and Heating
indicator
will flashes alternately on LCD of the remote control.
User can preset the remote control type depending
on the air conditioner type you have purchased as follows:
Press any button when
Press any button when
If you don not press any button within 12 seconds, the remote control will be set as Heat Pump
automatically.
Back-light function(optional)
Hold down any button of remote control for about 2 seconds, back-light turns on. Release the
button, it lights off automatically 10 seconds later.
flashes, Heat Pump will be set.
flashes, Cooling Only will be set.
12
Timer
Fan
Mode
Airc ond
ition er
Signal receptor