INTRODUCTION AND SAFETY
Thank you for purchasing this product.
This tool is an electric pump. It is used for pumping water and other similar water applications.
After opening the package, please ensure that the products are complete.
If the products are damaged or there is something missing, please do not use it and bring it back
to your dealer.
If you give this tool to another person, please give him this instruction manual.
Danger type and source:
The personal injury or death is likely to be caused in case of
Danger
refusing to obey this danger notice.
1.
In order to operate the equipment safely, the users shall care- fully read and understand the
instructions before the first application.
2.
The users shall obey all safety instructions. Otherwise, you and others may suffer from injury.
3.
You shall preserve all application and safety instructions for the further reference.
4.
The equipment shall be used when it has normal functions. 4.Please use the equipment
according to the safety and technical requirements as specified in the instructions.
5.
The semi-stationary and static form of the equipment is designed to be transferred to the
house and garden: Spray water and make watering.
6.
The equipment shall be used within its performance range. Please don't use the equipment
which has abnormal switch.
7.
The equipment is prohibited to be used for providing water or conveying food.
8.
Please don't use the equipment in the room which contains the inflammable and
combustible liquid or gas.
9.
When the components which fail to be tested and recognized by manufacturers are
improperly used, the equipment is likely to suffer from the unforeseen damage.
10. Any application which deviates from the intended purpose as specified in the instructions
will be considered as the unauthorized application, as a result, the generated problems are
independent of the manufacturers.
11. Please ensure that the closed equipment will not be started again by mistake.
12. The equipment shall be connected to the socket which has correct installation and
grounding.
13. The fuse wire shall serve as the current circuit breaker when the residual current exceeds
30mA.
14. Please ensure that the power supply can satisfy the connection regulations before the
equipment connection.
15. Please don't bend, extrude, pull or drive the power wire to avoid the related dangers caused
by line breakage. 16.Please check the plug and power cable before application.
16. When the power cable has been damaged, please disconnect the plug immediately. Please
don't use the equipment which has damaged power line.
17. When the equipment is idle, please ensure that the plug has been pulled out. Meanwhile,
the equipment has been closed, then, unplug the power supply.
ENGLISH
8