Hamilton Beach BrewStation 40540 Manual Del Usuario página 5

840172401 ENnv11.qxd:Layout 1
How to Make Coffee
6
Do not spill coffee grounds in stem
assembly.
10
NOTE: To avoid clogging coffee tank
seal/filter assembly with grounds, do
not tip urn to dispense coffee.
11/11/08 4:39 PM Page 5
(cont.)
7
Replace lid.
11
8
NOTICE: To avoid damage, do not
plug in when there is no liquid inside.
NOTES:
• Urn will automatically switch to Keep
Warm and maintain fresh, hot coffee
until unplugged. If keeping coffee
warm for a long period, remove coffee
basket and stem assembly when cycle
is complete. This will prevent bitter oils
in the grounds from affecting the flavor
of the coffee.
WARNING! Burn Hazard. The metal
urn parts will be hot. Use a pot holder
or oven mitt to remove the lid.
• To make additional coffee, rinse lid,
coffee basket, stem assembly, and
tank with cold water and repeat
Steps 1 through 8.
9
When brewing is complete, percolation
stops and ready indicator light changes
from red to green. Coffee is ready to
serve.
• To reheat coffee, remove coffee basket
and stem assembly. Lock lid in place
and plug in unit; then turn on for 20 to
60 minutes, depending on amount of
coffee remaining. Do not reheat if less
than 20 cups are left in the urn.
TO HEAT WATER:
(for instant coffee, hot cocoa, or tea)
1. Remove lid, coffee basket, and stem
assembly. Fill urn with cold water to
desired level.
2. Place stem assembly and coffee
basket into heating unit well.
3. Place lid onto coffee urn and turn to
lock. Plug in urn and let it complete
a perk cycle. Water is hot when the
ready indicator light glows.
5