Publicidad
Idiomas disponibles
Idiomas disponibles
Owners Instructions
30-Foot Retractable
Tri-tap Extension Cord Reel
with Circuit Breaker
Model No. : LD2030 163 9 & LD2030 143 9
CAUTION: Read all instructions and warnings before Operating!
SAVE THESE INSTRUCTIONS! READ ALL INSTRUCTIONS!
WARNING: To avoid serious injury or death from electrical
shock or fire.
1. DO NOT handle this fixture or try to plug it in when your hands
are wet or damp or when you are standing on a wet or damp
surface or in water.
2. This fixture MUST ALWAYS BE USED in accordance with all
electrical and safety codes and ordinances, including the most
recent National Electric Code (NEC) and with the Occupational
Safety and Health Act (OSHA) Volume 1 on General Industry
Standards and interpretations.
3. ALWAYS make certain that the power source conforms to the
requirements on the fixture.
4. ALWAYS disconnect the power before servicing or inspecting
the fixture for any reason.
5. This fixture IS ONLY FOR USE ON 110-125V and is equipped
with an approved 3 conductor cord with a 3-prong, grounded
plug. TO REDUCE THE RISK OF ELECTRICAL SHOCK, it
should only be plugged into a properly grounded 3-prong outlet.
6. FIXTURE IS NOT WATERPROOF and is not intended for use in
showers, saunas or in potentially wet locations. ALWAYS keep
this fixture away from sinks, tubs, showers, etc. NEVER attempt
to pick up plugged-in power tools or appliances should they fall
into standing water. Fatal Electrocution could result!
7. This fixture comes equipped with a 3-prong grounded plug. DO
NOT remove the 3rd prong or otherwise try to modify the plug. If
it will not fit the outlet, have the proper outlet installed by a
qualified electrician. Improper connection of the grounding
conductor can result in a risk of electrical shock.
8. NEVER attempt to plug the fixture into a non-grounded outlet or
extension cord and ALWAYS be sure that the extension cord is
in good electrical condition.
9. This fixture is intended for use as a general indoor power
source. DO NOT use in potentially dangerous locations, such as
in flammable or explosive atmospheres.
10. Keep away from heating vents, radiators, or other sources of heat.
11. KEEP OUT OF REACH OF CHILDREN.
ELECTRICAL RATING
WARNING: DO NOT OVERLOAD!
Check the amperages of the tools or appliances to be
plugged into the outlets of the extension cord reel.
Listed below are the maximum amperage ratings.
Model
Cord Length
LD2030 163 9
30FT
LD2030 143 9
30FT
OPERATION
Plug into any 110-125V standard wall outlet. Depress switch in
handle to turn the light on. Plug up to three (3) electrical appliances
into the Triple-Tap outlet.
Pull cord out to desired length and stop. If cord does not hold,
continue to pull cord slowly, stopping every four inches. This will
engage lock. To retract, pull cord out 2 to 4 inches and guide the
cord slowly back into the reel.
Note: 1. Outlet is un-switched and energized at all time. DO NOT
OVERLOAD !
2. Cord length is 30 Ft fully extended; DO NOT pull on cord
after cord is fully extended.
Caution: To Avoid Possible Injury - Do not allow cord to fly back into
Cord Type
Maximum outlet Rating
/Gauge
(Total for four outlets)
125V, 60Hz, AC
16/3 SJT
1250 Watts, 10 Amps
125V, 60Hz, AC
14/3 SJT
1625 Watts, 13 Amps
the reel unrestricted. Guide cord slowly back into the reel.
CIRCUIT BREAKER OVERLOAD PROTECTION
The reset button for the circuit breaker is located on the side of
tri-tap. If unit is overloaded circuit breaker will trip (black reset
button will pop out).Remove overload, wait two minutes, then reset
by pressing black button.
INSTALLATION
Ceiling Mount (Fig. 1)— 360° Rotation
1. Select location within 2 feet of an electrical
outlet.
2. Screw the Hanger Hook into a stud in the
ceiling.
3. Hang the reel on the hook.
4. Use pliers to close the hook so the reel is
secure and won't fall off.
5. Adjust Cord Stop so outlet hangs at desired
length when cord is retracted.
6. Plug the power cord into the outlet.
Optional Wall Mount (Fig. 2) — 180° Rotation
1. Select location within 2 feet of an electrical outlet.
2. Take U shaped bracket "A" and attach
to wall, in a stud, with the screws
provided.
3. Place hanger bracket "B" inside
U-shaped bracket "A" lining up small
hole in the brackets.
4. Insert locking pin "C" through lined-up
holes.
5. Adjust Cord Stop so outlet hangs at
desired length when cord is retracted.
6. Plug the power cord into the outlet.
MAINTENANCE
WARNING: UNPLUG UNIT BEFORE PERFORMING ANY
MAINTENANCE.
Remove dirt and grime as soon as it accumulates. Use a soft, damp
cloth and a mild soap, if needed. Be sure not to get the electrical
plug wet. NEVER submerge any part of the Cord Reel in any
solution to clean it.
DO NOT USE solvents such as gasoline, turpentine, etc. to clean
unit.Keep reel cord clean to assure smoothest automatic retraction.
To clean, simply pull cord to its full length and allow to retract
through a dampened rag. Pull out full length again and allow to
retract through clean rag sprinkled with talcum powder.
DRY THOROUGHLY BEFORE PLUGGING BACK INTO OUTLET.
LIFETIME LIMITED WARRANTY
All REELCRAFT products are individually tested and inspected for
defects in material and workmanship before leaving the factory.
Should your REELCRAFT product ever fail due to faulty workman-
ship or material, simply return it to the original place of purchase for
a replacement. Our Lifetime Return Policy is limited to the replace-
ment of the original purchase. No other liability, responsibility or
warranty is expressed or implied including any regarding merchant-
ability or fitness for a particular purpose.
REELCRAFT Industries, Inc.
One Reelcraft Center
P.O. Box 248, Columbia City, IN 46725-0248
www.reelcraft.com
Fig. 1
C
B
A
Fig. 2
06/2009
Publicidad
