Adaptec VideOh! AVC-2000 Primeros Pasos página 7

Plugging In
Before installing your drivers, you must connect your analog video
device to the AVC-2000 card using either the provided A/V cable
or an S-Video cable (not included). Your device may require it's
own proprietary cable.
Connect the Audio-L (white) and
Audio-R (red) ports to the audio
ports on the analog video device
Connect the S-Video port to the
video port on the analog video
device
Connect the Video (yellow) port to
the video port on the analog video
device
!
Caution: Do not use both the S-Video and the Video ports
simultaneously.
Installing Drivers and Software
After you have installed the AVC-2000 and connected your video
device, follow these steps:
1 Turn on your computer and when prompted by the hardware Install
Wizard, insert the VideOh! Installation CD into your CD-ROM drive.
If the installation screen appears next, exit out of the program
before installing the drivers.
2 Follow the on-screen instructions.
If you are using Windows 98SE, you may need your
I
Windows 98SE CD to complete the installation.
If you are using Windows 98SE and the driver file being
I
installed from the VideOh! installation CD is older then the
existing driver file, you may get a version conflict message.
Select to keep the newer driver file.
If you are using Windows XP, you may see a warning
I
message about Microsoft Windows logo certification. Click
Continue Anyway.
4