Matco PWH4000 Manual De Instrucciones página 2

PWH4000 Large Window Shade 10 Welding Helmet
•Be sure to read all safety warnings as well as instruction manuals before use of this helmet.
•Never place this helmet on a hot surface.
•This helmet does not provide protection against severe impact hazards, including grinding discs, explosive devices and/or
corrosive liquids. In the presence of these hazards, other protection must be used.
•Do not make modifications to either the filter or the helmet, unless specified in this manual. Do not use replacement
parts other than Matco replacement parts specified in this manual. Any unauthorized parts or modifications will void the
warranty and could expose the user to risk or personal injury.
•Wear ANSI approved safety goggles and ear protection at all times during use of this welding helmet. The lens is
breakable and does not provide complete protection from flying particles.
•Do not use any solvents on screen or helmet components.
•Use between temperature range of -10 degrees C to +55 degrees C (14 degrees F to 131 degrees F).
•Storing temperature of -20 degrees C to +70 degrees C (-4 degrees F to 158 degrees F).
•Do not immerse helmet in water. To clean use a damp soft cloth only.
•Regularly inspect/replace front cover lens if cracks, scratches, or other damage occurs.
•Caution: During welding operation, dust containing chemicals known to cause cancer and birth defects may be produced.
In order to reduce risk, adequate ventilation when welding is necessary and important.
•In order to reduce risk of personal injuries, inspect this helmet frequently and replace worn or damaged parts.
PWH4000 2 08/23/06