Cleaning And Care - Genie LA 500 A4 Manual De Instrucciones

Change between hot and cold laminating
1. You can easily change to hot laminating by setting the switch to 'Hot'
whenever you have been using the machine in the cold laminating mode. Wait
until the green LED has lit up after approximately 5 minutes. The machine is
ready for hot laminating now.
2. Now proceed as described by point hot laminating.
3. Set the switch to 'Cold' whenever you have been using the hot laminating
mode and you would like to change to the cold laminating mode. Please note
that the cooling down time amounts to approximately 2 hours for switching
over from hot to cold laminating. You can only begin the cold laminating – as
described by point "Cold laminating" – whenever the LED lights up green.
ATTENTION:
When the laminated pouch is ejected from the laminating film output it is still hot und
its shape may change slightly. For this reason, allow the laminated pouch to cool
down for at least 1 minute before touching it.
NOTE:
Do not feed the laminator further with foil in case of a blockage. Turn off the device
immediately!
Clearing a blockage of the film
1. This machine is equipped with a film blockage function in order to resolve any
blockage of the film (ABS).
2. At the start of the lamination process, the pouch may be pulled in at an angele
or jam itself inside the appliance.
3. Slide the Anti-Blocking switch (ABS) into position ABS. The laminating pouch
is not pulled any further in.
4. Remove the lamination pouch completely from the machine's feed opening or
delivery opening.
5. After you have resolved the blockage of the film and released the ABS switch
put it back to the desired foil thickness. Re-start the lamination process.
Attention: If the ABS switch have been paced at ABS position for a long time,
pleas slide the switch to the deird foil thickness 80 or 125 mic, and the
machine need to heat up. Please wait until the LED "Ready" glows.
6. Please contact our service-hotline if there is a blockage of the film again.

Cleaning and care

1. Please pull out the plug from the mains socket outlet always, in order to clean
the machine. Take care while doing so that the plug does not come into
contact with any liquids.
2. Allow the machine to cool down before cleaning it.
3. Clean the machine with a slightly moist, soft cloth. Do not use any caustic or
abrasive cleaning agents while doing so.
11