Evercraft 899-3261 Instrucciones De Operación página 4

• Tighten the gun to the cup securely with the nut and fitting supplied.
• Be sure to have the proper air pres s ure at the gun to operate. Proper air pres s ure for the large spray guns should not exceed 35 PSI
for lacquer and 43 PSI for enamel, and for the small spray gun, should not exceed 30 PSI.
• Adjust fluid control screw and spray width adjustment screw to your desired pattern before using on pro d uc t ion.
• Clean all parts after use.
In normal use, the nozzle wings are
hor i z on t al as shown here. This pro v ides a
ver t i c al fan-shaped pat t ern which gives
max i m um, even ma t e r i a l coverage as the
gun is moved back and forth par a l l el to the
sur f ace being fin i shed.
899-3261
FOR BEST PERFORMANCE, PLEASE BE SURE TO DO
THE FOL LOW ING BEFORE USING THIS TOOL
AdjusTmENTs
Air flow adjustment screw
Turn right to decrease flow,
left to increase.
sprAyiNg
Spray pattern may be in f i n ite l y adjusted
from round to flat.
Fluid control screw
Turn right to decrease flow,
left to increase.
Spray width adjustment screw.
Turn right for round, left for fan.
Set inlet pressure at no more than 43 PSI for the large
spray guns and 30 PSI for the small spray gun. For op t i m um
per f or m ance, some ma t e r i a ls may spray better at lower PSI
ratings. If unsure, always test at PSI ratings before using on
final production. Try spray. If it is too fine, de c rease the air pres-
sure or open fluid control screw. If the spray is too thick, close
the fluid control screw. Reg u l ate the pat t ern width and repeat
ad j ust m ent of spray as needed.
4 09/09/10