GE Advantium PSB9240DF Instrucciones De Instalación página 9

Preparation
NOTE: MODEL ZSC2202
INSTALLATION PREPARATION WITHOUT AN ACCESSORY STORAGE DRAWER FOR THIS MODEL.
PREPARE THE OPENING
Installation over a GE/Monogram Oven:
30"
21"
45-1/4"
Min.
* For existing cutouts, a maximum width of
28-1/2" is acceptable. If the opening is slightly
wider, secure a furring strip on each side of the
cutout for securing the oven.
• If you are replacing a GE/Monogram electric
double oven with the combined installation of
an Advantium 240V and a single oven, use the
dimensions shown. The middle rail separating
the two openings may need to be larger than
the 2" minimum shown.
Installation Preparation
WITH
CANNOT BE INSTALLED WITH AN ACCESSORY STORAGE DRAWER. SEE
(CONT.)
23-1/2" Construct
Solid Bottom
Min. 3/8"
Plywood
Supported by
25-1/4"
2x4 or 2x2
Min.*
Runners all
Four Sides
2" Min.
(3" recommended)
Per Oven
Requirement
an Accessory Storage Drawer
PREPARE THE OPENING
Installation over a GE/Monogram Oven
and Warming Drawer:
30"
45-1/4"
Min.
Per warming drawer requirement
* For existing cutouts, a maximum width of
28-1/2" is acceptable. If the opening is slightly
wider, secure a furring strip on each side of the
cutout for securing the oven.
NOTE: Additional clearances between the cutouts
may be required. Check to be sure the oven
supports above the Warming Drawer location do
not obstruct the required interior depth and height.
See Warming Drawer installation instructions for
details.
CAUTION
mounting surface must be capable of supporting
the cabinet load, in addition to the added
weight of this approximate 80-pound oven and
30-pound drawer, plus additional oven loads of
up to 50 pounds or a total weight of 160 pounds.
PRECAUCIÓN
la superficie de montaje debe poder soportar
la carga del gabinete, además del peso
aproximado de 80 libras del horno y las 30
libras del cajón, más las cargas adicionales
del horno de hasta 50 libras o un peso total de
hasta 160 libras.
9
23-1/2"
21"
Per Oven
Requirement
For personal safety, the
Para seguridad personal,
(CONT.)
Construct
Solid Bottom
Min. 3/8"
Plywood
Supported
by
2x4 or 2x2
Runners all
Four Sides
2" Min.
(3" recommended)
2" Min.